ECU Master EMU Black R50 MINI COOPER Engine Management Unit

ECUMaster Mini Cooper R50 EMU Black Plug in ECU

The EMU BLACK PNP ECU series was created to simplify the connection of the EMU BLACK ECU to popular cars. The ECU has a preloaded base map for an unmodified stock car which is a very good starting point for tuning the engine.

Base map available

The list below summarizes all EMU BLACK PNP ECU features for the Mini Cooper R50

- Precise fuel control based on Speed Density strategy

- Advanced ignition angle control

- Real time tuning

- Wideband oxygen sensor support (LSU 4.2 or LSU 4.9)

- Knock control

- Drive by wire support with auto-calibration feature

- Fuel auto-tune function

- Support of OEM CAN stream

- Sport functions like traction control, boost control, rev matching, gear cut, etc.

- Safety features like oil pressure cut, stuck throttle detection, lambda guard and more - Easy and intuitive software

The EMU features more built-in value than any other aftermarket ECU. It easily matches the functionality of other stand-alone management systems with advanced VE fueling strategies and multiple inputs and outputs. Unlike many other ECU systems, EMU has built-in wideband lambda input (Bosch LSU 4.2, and LSU 4.9 sensors wire directly in), MAP control connector (4 bar MAP internal MAP sensor), 2 EGT probe inputs and an input to directly connect a Flex Fuel ethanol content sensor. All of this provides greater flexibility, reduces costs and negates the requirement for external or supplementary signal conditioning control systems and the associated wiring that other management systems require.

Outputs

• Injector - 6 protected outputs 5A, low side 
• Ignition - 6 outputs 7A(15A peak) (passive & active coils supported)
• Aux - 6 protected outputs 5A, low side
• Other Outputs - Full bridge up to 7A, can be used as separate outputs or 2 H-Bridges
• WBO Heater - Protected low side up to 5A 
• Communication - Serial, CAN BUS 2.0B

Inputs

• Analog - 9 inputs, resolution 10Bits, 0-5V (protected)
• EGT - 2 for K-Type thermocouple
• Knock Sensor - 2 inputs
• Oxygen Sensor - LSU 4.2, LSU 4.9 or Narrow band
• Trigger - 3 (primary, 2 cams) Hall/ VR software selectable
• VSS - 1 (Hall / VR)
• Flex fuel - Yes 
• Switch - 3 inputs, switched to ground

Please contact us if you need any further information about this ECU or have questions regarding it's suitability for your project.

There are also plug in harnesses for this ECU to fit specific applications. 

Note this product comes from Europe and could take up to 10 working days to arrive.