This is the latest Link G4X Subaru WRX & STI V3-4 (97 - 98) Plug-in ECU.
Designed for the WRX V3-4 EJ20
- Please check your connector matches the header in the listed photo before purchasing.
- This ECU works for manual transmissions only.
- Air temp sensor highly recommended.
- Most factory features are supported.
Suitable Applications: GC8D GC8E WRX and STI from 09/1996 to 08/1998 G4X PlugIn Key Features (where applicable):
- Up to 6D fuel and ignition mapping
- Precision closed loop cam control (four cam, independent control)
- Sequential fuel delivery
- Digital triggering, all OEM patterns
- OEM idle hardware supported
- 5D boost control with three switchable tables
- Motorsport features - antilag, launch, flat shift
- Continuous barometric correction (on board)
- CAN port
- QuickTune - automated fuel tuning
- Individual cylinder correction
- USB tuning cable included
- Stats recording into on-board memory
- Gear compensations for spark, boost and fuel
- Real time selectable dual fuel, ignition and boost maps
- Sync and crank sensors can be a combination of Hall effect, variable reluctance or optical
- Boost control referenced to gear, speed or throttle position
- 512 mega bytes data logging memory
- Staged injection
- Knock with "windowing"
The following expansion connector inputs/outputs are provided: Expansion connector 1
- Gnd Sensor Ground Only
- +5V Low Current +5V Supply
- DI 5 Digital Input
- DI 6 Digital Input
- Volt 5 Analog 0-5V input
- Volt 6 Analog 0-5V input
- Temp 4 Temperature sensor input
- Temp 3 Temperature sensor input
Expansion connector 2
- Gnd Sensor Ground Only
- +5V Low Current +5V Supply
- DI 9 Digital Input
- DI 10 Digital Input
- Volt 8 Analog 0-5V input
- Volt 9 Analog 0-5V input
- Ign 7 Ignition 7 Auxiliary Output
- Ign 8 Ignition 8 Auxiliary Output
Link G4X ECUs do not require the use of an air flow meter. The engine can be converted to speed density using a MAP sensor and an intake air temperature (IAT) sensor (IAT sensors sold separately)
If you are wanting more boost than the OEM 2 bar map sensor, We can provide a 3 or 4 Bar sensor at extra cost.
The G4X Subaru WRX & STI V3-4 plug-in ECU comes with a non-engine-specific base map. The ECU will need to be configured for the engine type and then tuned by a professional. The ECU comes with free PCLink software.
We can also provide the following with your new Link ECU at an added cost:
- Fuel System Upgrades
- Turbosmart Wastegates, Blow off valves and Fuel Pressure Regulators
- Boost Control Solenoids
- Dyno Tuning
- Engine sensors and plugs etc
- Full Link ECU engine wiring installation available at an extra cost
